MTS SWIFT 10 MC Sensor User Manual
Page 65
Road and Track Vehicles
SWIFT 10 MC Sensors
Installing the Transducer
65
F.
Loosely secure both rim hub adapters to the modified rim using the M6
socket head cap screws, a washer on each side of the rim hub adapters,
and Nylok nuts (as required).
G.
Following the outer bolt pattern sequence shown in the
Bolt Torque
Sequence
figure, torque the twenty M8 bolts (1 through 20) on one side
of the transducer to the value for the first increment shown in the
table.
Repeat this step for the twenty fasteners on the other side of the
transducer.
Note
To minimize negative clamping effects, you must torque the bolts in the
sequence and increments shown.
H. Repeat Step 5G for the final increment.
I.
Repeat this entire step for the other wheel, as necessary.
J.
Continue with Step 6.
Bolt Torque Sequence
6. Wipe the unpainted mating surfaces of the components needed to complete
the assemblies with a clean dry cloth.
Use cottons swabs or other soft tool to clean the coupling teeth on the inner
hub adapters and transducer.
Bolt Torque Increments
T
ORQUE
I
NCREMENT
M8 B
OLT
S
IZE
1st Increment
19 N•m (14 lbf•ft)
Final Increment
38 N•m (28 lbf•ft)
S10MC-15
F
4
G
8
12
17
13
C
A
6
1
20
15
Inner Bolt
Pattern
3
E
Outer Bolt
Pattern
D
B
H
10
19
16
14
18
11
7
2
5
9