MTS SWIFT 10 MC Sensor - Manual (Page 59)

Road and Track Vehicles
SWIFT 10 MC Sensors Installing the Transducer 59
Road and Track Vehicles
Equipment required
This procedure can be performed by one person. To install the SWIFT 10 sensor,
you will need the following equipment:
• Inner hub adapter (see next figure)
• Stock spoked rim or modified rim (see next figure)
• Outer hub/rim adapters
• Washer plate (see next figure)
• Small set of metric hex-head wrenches
• Metric socket head drive set (up to 10 mm) with extension
• Molykote g-n paste, 2.8 oz. tube (MTS part number 011-010-217)
• Nikal based anti-galling compound (MTS part number 011-354-902)
• Transducer mounting bolts (per transducer)
1
20 size M8 X 1.25 mm X 50 mm long
8 size M8 X 1.25 mm X 75 mm long
8 washers 17 mm O.D. X 8.4 mm I.D.
• Torque wrenches, capable of the following ranges:
19–38 N•m (14–28 lbf•ft)
95 N•m (70 lbf•ft)
• Cables (transducer and BNC, plus customer-supplied from transducer
interface to data recorder)
• Tie wraps
• Data recorder
• Power supply–12 V DC or suitable 12 V DC vehicle battery 2
1. Lengths shown are for reference only. Verify lengths for you specific rim
and hub design.
2. Not all vehicles have alternators to maintain the charge to the vehicle battery
if the battery is also used by the SWIFT sensor and the data acquisition
system. Additional batteries and/or chargers may be necessary.