MTS SWIFT 10 MC Sensor - Manual (Page 75)

Road and Track Vehicles
SWIFT 10 MC Sensors Installing the Transducer 75
Note When the inner hub is fully assembled, the encoder index mark is
aligned with the square head set screw on the inner hub adapter and the
index mark on the slip-ring is aligned with the cable slot in the axle
spacer. When the set screw and cable slot are aligned with each other,
the index mark is under the encoder sensor.
3. Rotate the tire, as necessary, until the Fz on the axes icon (see the next
figure) printed on the transducer label (or the mark you made on the hub
adapter during assembly) is pointing up.
4. For the front wheel: Attach the inclinometer to the T shaped level bracket
using the two 6-32 UNC fasteners provided.
Apply Locktite 222 to the threads on the fasteners. Torque each fastener to 2
N•m (18 lbf•in).
5. Install the level bracket and inclinometer on the transducer.
A. Insert the inclinometer bracket through the spokes of the wheel and
push the dowel pin into the beam hole. See the next two figures.
The inclinometer can be mounted horizontally or vertically, depending
on the accessibility to the beam holes. For horizontal mounting the
wheel should be adjusted such that the inclinometer reads 0°, ±0.1°.
For vertical mounting the wheel should be adjusted such that the
inclinometer reads 90°, ±0.1°.
Inclinometer Mounting for Front Wheel
Axes Icon
S10MC-22
Level
Bracket
Beam
Holes (4)
Spoke Adapters (2)
S10MC-16
Inclinometer