MTS SWIFT 10 MC Sensor - Manual (Page 71)

Road and Track Vehicles
SWIFT 10 MC Sensors Installing the Transducer 71
11. Use the stock axle, axle nut, washers, and tension adjust/slide plates, as
required, to mount the wheels on the vehicle.
Orient the flat on the axle spacer to the top of the swing arm (for rear wheel)
or the front of the fork tube mount (for front wheel).
Attach the anti-rotate bracket to the axle spacer and against the swing arm or
fork tube mount using the two 6-32 UNC fasteners provided.
Apply Locktite 222 Threadblocker to each fastener and torque to 2 N•m (18
lbf•in).
Torque the axle nut to the manufacturers specifications.
12. Route cable along the swing arm or front fork tube using tie wraps to secure
it. Ensure the cable is routed such that it will not contact any moving parts,
such as the brake disk or wheel. Allow enough slack to accommodate the
range of motion of the front fork tubes.