MTS SWIFT 10 MC Sensor - Manual (Page 70)

SWIFT 10 MC Sensors 70
Road and Track Vehicles
Installing the Transducer
C. Place the inner hub adapter with the slip ring/encoder over the
transducer.
Align the connectors on the hub adapter with the connectors on the
transducer. Push the hub adapter onto the transducer to fully engage the
connectors.
D. Install the eight M8 bolts and flat washers through the hub adapter on
the slip ring side.
Lubricate the threads and under the head of each fastener with
Molykote g-n paste.
E. Following the inner bolt pattern sequence shown in the Bolt Torque
Sequence figure on page 65 , torque the eight M8 bolts (A through H) to
the value for the first increment shown in the Bolt Torque Increments
table on page 65 .
F. Repeat Step 9E for the final increment.
G. At this point you can fully tighten the spokes and true-up the wheel per
the manufacturers specifications.
10. Repeat this entire procedure for the other wheel, as necessary.
Typical Wheel Assemblies (rear shown)
S10MC-11
Slip Ring/Encoder
Stock Axle
Motorcycle Frame
Anti-rotate/Cable
Conduit Bracket
Slip Ring/Encoder
Output Cable
Motorcycle
Frame
Stock Axle
Nut/Washer
Center Line of
Rim and Transducer
Center Line of
Rim and Transducer
Standard Spoked
Rim Assembly
Modified
Rim Assembly