INFICON STM-2XM 2-Channel Rate/Thickness Monitor - Manual (Page 40)

3 - 4
PN
07
4-
61
4-
P1
A
STM-2XM Operating Manual
3.1.3 Changing a Parameter
There are two types of parameters, enumerated and numeric. Enumerated
parameters have a list of fixed choices. Numeric parameters allow a number to be
entered. To change a parameter,
1 Press PROG/ENTER.
2 Rotate the control knob to select Edit Active Film.
3 Press PROG/ENTER to display the Editing Film menu for the active film (see
Figure 3-4 ).
Figure 3-4 Editing film settings
To edit the density, for example, rotate the control knob clockwise to select
DENSITY, then press PROG/ENTER. The DENSITY numeric parameter editor will
be displayed (see
Figure 3-5 ).
Figure 3-5 Numeric parameter editor
 Numeric parameters are changed one digit at a time.
 Each digit may only be incremented, and rolls over from 9 to 0.
 To select the next digit, rotate the control knob counterclockwise.
 To increment the selected digit, rotate the control knob clockwise.
 When finished, press the PROG/ENTER button.
 To cancel the entry, press the CANCEL/BACK button.
Counterclockwise
Clockwise
three clicks
two clicks