SkyTrak 6036 Service Manual - Manual (Page 68)

Section 5. Wheel Assembly, Tires, and Axle
5-23 Model 6036 S/N 9B0499 and Before
c. Cleaning and Drying
1. Clean all parts with approved petroleum based
cleaner.
2. Use clean lint free towels to dry components
after cleaning. DO NOT dry bearings by
spinning with compressed air. This can
damage mating surfaces due to lack of
lubrication.
3. After drying, components should be lightly
coated with oil or rust preventive to protect
them from corrosion.
d. Inspection and Replacement
1. If yoke shaft (Fig. 5.12) shows wear in the
area of oil seal (14 and 17, Fig. 5.13) contact,
replace it.
2. Replace all oil seals (16 and 17), O-rings (22
and 23), and back up rings (20 and 21)
regardless of condition.
3. Replace bearing (14) if it is worn, pitted, or
damaged.
4. Replace outer spline (3) if it is worn, pitted,
scored, or chipped.
5. Replace all weak, broken, or damaged springs
(4).
6. If any one of lining plates (9) or rotor discs (8)
show wear or scoring, replace the complete
stack.
NOTE: If a new stack wasn’t installed, keep the
stack of plates and discs in exactly the same order
in which they were removed.
Fig. 5.14 Plate and Disc Alignment
e. Assembly
Refer to page 55 of Spicer ® Dana Maintenance
Manual for Axle Models PS/PR-7036 for assembly
instructions.
f. Installation
1. Install dust slinger (37, Fig. 5.16) on end yoke
assembly (38).
2. Refer to page 54 of Spicer ® Dana Maintenance
Manual for Axle Models PS/PR-7036 for
installation instructions.
g. Bleeding
1. Be sure all pressure lines are secure and don’t
leak.
2. Bleed the pressure release section of the park
lock by pressurizing the side inlet port and
allowing air to escape from the top port.
3. Pressure should not exceed 100 psi (690 kPa)
during bleeding.
4. Apply sufficient pressure to release the park
lock and allow for the checking of system
operation.
5.2.7 Carrier Assembly
Refer to paragraph 5.2.1 for axle assembly
removal and installation instructions. Refer to
pages 38 through 53 of Spicer
® Dana Models PS/
PR-7036 Maintenance Manual for removal and
installation of carrier from axle housing; removal
and installation of differential from carrier, and
differential and pinion disassembly and assembly.
LINING PLATE
THRUST PLATE
CAPSCREW
SHOULDER BOLT
PIN
MA0291