SkyTrak 6036 Service Manual - Manual (Page 106)

Section 8. Engine
8-20 Model 6036 S/N 9B0499 and Before
37
5
6
16
FUEL RUN
SOLENOID
WATER TEMP.
SENDER
ENGINE
STARTER
ENGINE HARNESS
TO BATTERIES
NOT USED
TRANSMISSION
TEMP. SWITCH
13. Disconnect the engine wire harness at the
following components, Fig. 8.26:
• Starter
• Starter Ground Cable
• Starter Relay
• Neutral Start Switch (on transmission)
• Transmission Temperature Switch
• Low Oil Pressure Sender
• Emergency Pump Oil Pressure Switch
• Water Temperature Sender
• Fuel Run Solenoid
• Alternator
• Thermo Start Plug
Pull harness off of engine and forward on
forklift so it is out of the way.
14. Detach and plug fuel lines as required at fuel
pre-filter and fuel filter.
15. Detach throttle cable from engine as follows:
(a) Remove cable clamp securing throttle
cable to throttle cable bracket.
(b) Disconnect the throttle cable from the fuel
injection pump.
16. Remove the transmission control cables from
the connector kit on the transmission as
follows:
(a) Remove the cable clamps securing the
control cable to the connector kit, Fig. 4.4.
(b) Disconnect the control cables from the
swivel linkage.
17. Disconnect transmission drive shaft from the
transmission:
(a) Remove transmission cover from forklift.
NEUTRAL START SWITCH
(TRANSMISSION MOUNTED)
GROUND CABLE
ALTERNATOR
STARTER
RELAY
29
19
27
29
5
14
37
18
EMERGENCY
PUMP OIL
PRESSURE
SWITCH
LOW OIL
PRESSURE
SENDER
10
28
34
15
31
5
38
Fig. 8.26 Engine Harness Connections
BACKUP
ALARM
4
19
28
MA0381