SkyTrak 6036 Service Manual - Manual (Page 48)

Section 5. Wheel Assembly, Tires, and Axle
5-3 Model 6036/6036T S/N 9B0499 and Before
W
H
E
EL
ASSEM
B
LY
solution from the tire.
These instructions cover tire removal and installa-
tion for the standard three piece wheel and for the
optional single piece wheel.
Instructions in italics refer to a tire with an optional
tube. You may use a tube if the tire doesn’t
provide an air tight seal.
Fig. 5.1 Tire Direction of Rotation and Valve Stem Positions for Tire Pressure Check, Fill and Evacuate
SOME TIRES HAVE THIS INSTRUCTION EMBOSSED IN SIDE WALL:
DRIVING TIRES MUST ROTATE
AS THE ARROW POINTS
(OTHER TIRES MUST ROTATE
IN THE OPPOSITE DIRECTION)
VALVE POSITION FOR CHECKING TIRE PRESSURE
AND FOR DRAINING HYDROFILL FROM TIRE
VALVE POSITION FOR
FILLING TIRE WITH
HYDROFILL AND AIR
HUB
WHEEL LUG NUT
TIRE
NOTE DIRECTION OF
TREAD PATTERN
ARROW POINTS TO LEFT
ON CAB SIDE OF FORKLIFT
NOTE: The calcium chloride hydrofill solution will
corrode a standard tire pressure gauge. Use a
corrosion resistant tire pressure gauge . Be sure
to flush the gauge with clear water after checking
a tire inflated with hydrofill and air.
Before you remove a tire from a wheel, use an
ejector tool to remove the valve core and use
ejector tool and pump to remove calcium chloride
ARROW POINTS TO RIGHT
ON BOOM SIDE OF FORKLIFT
MA0211
MA0212
MA0213
MA0214