SkyTrak 6036 Service Manual - Manual (Page 152)

9-39 Model 6036 S/N 9B0499 and Before
Section 9. Hydraulic System
9.2.6 Steering Cylinder
a. Removal
1. Engage the park lock, place the travel select
lever in neutral, and stop the engine.
2. Operate the hydraulic controls after the engine
has stopped to relieve any trapped pressure.
3. Disconnect the hydraulic lines from the
steering cylinder and cap and plug open
connections.
4. Remove cotter pins (1, Fig. 9.18) and nuts (2)
securing the cylinder socket assemblies (3) to
carrier (4) and knuckle (5).
Warning !
Warning !
1. Cotter pin (2)
2. Nut (2)
3. Cylinder Socket Assembly
4. Carrier
5. Knuckle
Fig. 9.18 Steering Cylinder Installation
Relieve hydraulic pressure before servicing any
hydraulic component. Escaping hydraulic fluid
under pressure can penetrate the skin causing
serious injury.
Wait for the hydraulic fluid to cool before servic-
ing any hydraulic component. Hot hydraulic fluid
can cause severe burns.
5. The steer cylinder socket is a taper fit in
knuckle. Use an impact fork to release the
socket from the knuckle.
6. Remove the cylinder from the forklift using a
strap sling and hoist or other suitable lifting
equipment.
7. Measure the total length of the fully retracted
cylinder with sockets in place and note or
record the distance. Loosen socket clamps
and unscrew the socket assemblies from the
cylinder.
b. Disassembly
1. Remove all dirt and grease from the steering
cylinder
2. Determine the direction that the gland (4, Fig.
9.19) will be turning when it is removed so that
the lockwire (10) will feed out through the tube
hole.
3. Using a sharp object, such as a screwdriver,
pry up one end of the lockwire from its hole in
the tube (1).
4. Using a spanner wrench, remove the gland
allowing the lockwire to work its way out of the
tube.
IMPORTANT: Protect the finish on the rod at
all times. Damage to the surface of the rod can
cause premature seal failure.
3
3
5
2
1
1
2
4
MA0591