SkyTrak 6036 Service Manual - Manual (Page 163)

Model 6036 S/N 9B0499 and Before 9-50
Section 9. Hydraulic System
Warning !
Warning !
4. Start the forklift engine.
5. Inspect connections at the control valve for
leakage.
6. Operate joysticks to test the operation of the
control valve and hydraulic system. Refer to
paragraph 9.1 for instructions on adjustment of
relief valve settings
7. Install the transmission cover.
Before starting the engine be sure all hydraulic
connections are tight and all tools are removed
from the forklift.
Warning !
9.3.2 Brake Valve
a. Removal
1. Retract the boom and support it in a horizontal
and level position.
2. Engage the park lock, place the travel select
lever in neutral, and stop the engine.
Wait for the hydraulic fluid to cool before servic-
ing any hydraulic component. Hot hydraulic fluid
can cause severe burns.
Relieve hydraulic pressure before servicing any
hydraulic component. Escaping hydraulic fluid
under pressure can penetrate the skin causing
serious injury.
3. Operate the brake pedal after the engine has
stopped to relieve any trapped pressure.
4. To gain access to brake valve (3, Fig. 9.28),
remove four hex head screws and lock
washers (1), to detach the lower panel (2)
which is located under the dash.
Fig. 9.28 Brake Valve Installation
3
4
5
5
5
6
6
MA0691
1. Hex Head Capscrew and Lock Washer (4)
2. Lower Panel
3. Brake Valve
4. Hex Nut (2)
5. Lock Washer (4)
6. Hex Head Capscrew (2)
2
1