BNC 1201 - 6 1/2 Digit Digital Multimeter - Manual (Page 92)

93
and ▷ buttons. Press ENTER on your selection. The locations of the
buttons are shown with red rectangle frames in Figure 4-26.
Procedures: MENU → SYSTEM → DISPLAY → {ON|OFF}
Figure 4-26
Remote Interface Operation
The following commands show how to control the display as well as how
to send a message to the display:
DISPlay {OFF|ON} (turns off or turns on the display)
DISPlay:TEXT > (displays the string you type in)
DISPlay:TEXT:CLEar (clears the message displayed)
4.4.2 Beeper
1201 multimeter beeps when some certain conditions are met or when
an error occurs. But there may be time you want to disable the beeper
for some operations. Although you can turn off the beeper, the click
sound you hear when a button is pressed will not be disabled. The beeper
state is stored in a volatile memory and the default will be restored when
the meter has been turned off or after a remote interface reset.
By disabling the beeper you will not hear the meter beeps when:
a new minimum or maximum is found in Min/Max operation.
a stable reading is detected and held.