2 rtd measurements, 1 2-wire rtd measurements – BNC 1201 - 6 1/2 Digit Digital Multimeter User Manual
Page 44

45
④
Press SHIFT + TEMP buttons.
⑤
Take the reading on the display.
Figure 3-12
3.7.2 RTD Measurements
There are three kinds of temperature measurements with RTDs: 2-wire,
3-wire and 4-wire measurements. You will find connection instructions
and measuring procedures in the following sections.
3.7.2.1 2-Wire RTD Measurements
How to measure temperature with 2-Wire RTD
The following Figure 3-13 shows theory diagram of 2-Wire RTD
measurement.
①
Use terminals switch to select front terminals.
②
Insert a specified adapter into the front terminals. Connect the low
thermal patch leads to the adapter as shown in Figure 3-14.
③
Configure sensor type and unit using CONFIG + TEMP and ◁ or ▷.
When ready, press ENTER button.
④
Press TEMP button.
⑤
Place RTD in the desired position and take the reading on the display.
3
5
4
1
2