Thermocouple – BNC 1201 - 6 1/2 Digit Digital Multimeter User Manual

Page 66

You can set up the RTD configuration either through the front panel

operation or through the remote interface operation.

Front Panel Operation

If you are using RTD, press CONFIG and then TEMP. Use ◁ and ▷ to

locate SENSOR submenu. Press ENTER to go to the submenu. Use ◁

and ▷ to locate your sensor type Press ENTER to select your desired

sensor type.

Choosing USER takes you to a menu where you can specify factors used

in the calculation equation to obtain the temperature. Use ◁ and ▷ to

move through the digits and △ and ▽ to change the numbers to a

desired value. Press ENTER to set the value.

Choosing SPRTD takes you to a menu where you can specify the seven

coefficients

that are used to determine the temperature. Use ◁ and ▷

to move through the digits and △ and ▽ to change the numbers to a

desired value. Press ENTER to set the value.

Remote Interface Operation

Use the following commands to set up the RTD configuration.

SENSe:TEMPerature:RTD:TYPE{PT100|D100|F100|PT385|PT3916|USER|SPRTD|NTCT}

SENSe:UNIT {Cel|Far|K}

SENSe:UNIT?

SENSe:TEMPerature:RTD:RZERo {<value>|MINimum|MAXimum}

SENSe:TEMPerature:RTD:ALPHa {<value>|MINimum|MAXimum}

SENSe:TEMPerature:RTD:BETA {<value>|MINimum|MAXimum}

SENSe:TEMPerature:RTD:DELTa {<value>|MINimum|MAXimum}

SENSe:TEMPerature:SPRTD:RZERo {<value>|MINimum|MAXimum}

SENSe:TEMPerature:SPRTD:A4 {<value>|MINimum|MAXimum}

SENSe:TEMPerature:SPRTD:B4 {<value>|MINimum|MAXimum}

SENSe:TEMPerature:SPRTD:AX {<value>|MINimum|MAXimum}

SENSe:TEMPerature:SPRTD:BX {<value>|MINimum|MAXimum}

SENSe:TEMPerature:SPRTD:CX {<value>|MINimum|MAXimum}

SENSe:TEMPerature:SPRTD:DX {<value>|MINimum|MAXimum}

Thermocouple