BNC 1201 - 6 1/2 Digit Digital Multimeter - Manual (Page 113)

114
※ Note: The icons, pictures and words will be changed or edited with
different versions without informing.
Figure 5-1 Figure 5-2 Figure 5-3
How to set up for GPIB interface
Insert GPIB interface card into the interface slot on the rear panel. Install
the 1201 application in your PC and execute the program. Click Tool tab
for Command Control, then type in your command. The icons and
buttons are shown with red rectangle frames in Figures 5-1, 5-2 and
5-3.
5.3 Remote Interface Commands
User can instruct the multimeter to take measurements using the SCPI
commands after the appropriate setup for their selected remote
interface.
The following conventions are used in SCPI command syntax. Triangle
brackets (<>) indicates that you must specify a value for the enclosed
parameter. The square brackets ([]) indicates that the parameter is
optional and can be omitted. The braces ({}) enclose the parameter
choices for a given command string. A vertical bar (|) separates several
choices for a parameter.
The MEASure? Command
Although it does not offer much flexibility, using the MEASure? Command
is the simplest way to program the multimeter for measurements. You
select the measurement function, range and resolution, the multimeter
1 2 3