BNC 1201 - 6 1/2 Digit Digital Multimeter User Manual
Page 84

85
limit you wish to set. Then use ◁ and ▷ to move through the digits and
△ and ▽ to increase or decrease the numbers to a desired value. Press
ENTER to set the value. The locations of the buttons are shown with red
rectangle frames in Figure 4-18.
Figure 4-18
How to make a limit testing
The locations of the buttons are shown with red rectangle frames in
Figure 4-19.
Select a measurement function for purpose except continuity and
diode.
Enable the limit operation by pressing SHIFT + RATIO buttons.
After enabling the limit function, user can set the limit value as
mentioned above.
Observe the displayed reading.
※ Note: Press SHIFT+RATIO again to disable this feature. The “MATH”
anunnciator on the display indicates the state of a mathematical feature.