BNC 1201 - 6 1/2 Digit Digital Multimeter - Manual (Page 101)

102
The locations of the buttons are shown with red rectangle frames in
Figure 4-31.
Figure 4-31
4.4.6 Stepping (Step)
Stepping is scanning with a specified time delay between taking input
signal through the defined channels.
※ Note: Setting range of scanner card is only limited on DCV, DCI, ACV,
ACI and Resistance functions.
How to program each channel with measurement function
Press CONFIG + SHIFT + FILTER for scanning configuration. Use ◁ and
▷ to scroll through submenus. Press ENTER on “SET SCAN CHA”
submenu. Use ◁ and ▷ to switch from channel 1 to channel 10, and
use △and ▽ to switch among the measurement functions. Leave an
unused channel with a blank space (----). Press ENTER when ten
channels are all defined.
How to configure scan count, scan interval and store
measurement readings
Press CONFIG + SHIFT + FILTER for scanning configuration. Use ◁ and
▷ buttons to scroll through submenus. Press ENTER to select
“OPERATION” submenu. Use ◁ and ▷ to switch among scan count
(COUNT), scan interval (TIMER) and store (STORE) options. Then press
ENTER on your selection. Use ◁ and ▷ to move through the digits and
△and ▽ to increase or decrease the numbers to a desired value. For