Sharp MX-M264N User Manual
Page 83
1-42
FINISHER
The finisher is equipped with the offset function, which offsets each set of output from the previous set.
In addition, each set of sorted output can be stapled.
PART NAMES
The following parts can be accessed when the finisher is open.
(1)
Output tray
Stapled and offset output is delivered to this tray.
The tray is slidable. Extend the tray for large output
(A3, A4R, B4, B5R, 12" x 18", 11" x 17", 8-1/2" x 14",
8-1/2" x 13", 8-1/2" x 13-1/2", 8-1/2" x 13-2/5",
8-1/2" x 11"R, 8K and 16KR sizes).
(2)
Lever
Use this to move the finisher in order to remove a paper
misfeed, replace staples, or remove a staple jam.
(3)
Staple case
This holds the staple cartridge. Pull the case out to
replace the staple cartridge, remove a staple jam, or
remove the punch scrap case.
(4)
Staple case release lever
Use this to remove the staple case.
(5)
Front cover
Open this cover to remove a paper, replace staples, or
remove a staple jam.
SUPPLIES
The finisher requires the following staple cartridge:
Staple cartridge
(approx. 5000 staples per cartridge x 3 cartridges)
MX-SCX1
(1)
(2)
(3) (4)
(5)
Use caution when you turn on the power and when printing is taking place, as the tray may move up and down.