Device control -67, Other settings -67, Device control – Sharp MX-M264N User Manual
Page 699: Other settings, Original feeding mode, Auto paper selection setting, Tandem connection setting, Detect standard in auto colour mode, Optimization of a hard disk, Clear all job log data
7-67
Device Control
These settings control devices installed on the machine. Touch the [Device Control] key to configure the settings.
Other Settings
Original Feeding Mode
The following original feeding modes can be set to
operate by default in copy, Scan to HDD, and image
send modes. When a mode is frequently used, this
saves you from having to select the mode in the special
modes each time you need to use it.
• Mixed Size Original (Same Width (Copy mode
only)/Different Width)
• Slow Scan Mode
• Blank Page Skip (image send*)
* Excluding fax mode and Internet fax mode.
Auto Paper Selection Setting
The paper types* that the Auto Paper Selection function will
select can be specified. Select one of the following settings:
• Plain Paper
• Plain and Recycle Paper
• Recycle Paper
The Auto Paper Selection function will not select any
paper types other than the paper types specified with
this setting.
* The paper type set for each paper tray using "
" (page 7-13) in the system settings (general).
Tandem Connection Setting
(When the hard disk drive is installed.)
When two machines are used as network printers using
TCP/IP protocol, use this setting to configure the port
number and IP address of the machine used as the
tandem slave machine.
Disabling of Master Machine Mode
To prohibit tandem transmission, enable this setting.
(There is normally no need to enable this setting.)
Disabling of Slave Machine Mode
To prohibit tandem reception, enable this setting. (There
is normally no need to enable this setting.)
Detect Standard in Auto Colour
Mode
To make it easier to detect a black and white original,
adjust the setting toward [Black & White]. To make it
easier to detect a colour original, adjust the setting
toward [Colour].
Optimization of a Hard Disk
(When the hard disk drive is installed.)
This function optimizes the hard drive of the machine by
defragmenting data. If a job is in progress, a message
will appear and optimization will not begin until the job is
finished. During optimization, the following operations
are not possible:
• Web page access, reception of print data
• Use of keys on the operation panel
• Turning off the power with the main power switch of
the machine.
• Auto Power Shut-Off
When optimization is completed, the machine will
automatically restart.
Clear All Job Log Data
(When the hard disk drive is installed.)
This is used to clear the entire job log. (There is normally
no need to use this function.)
A log file is kept of jobs run on the machine. The job log
can be used to check general use of the machine. The
job log can be written to a computer in CSV format using
a Web browser.
• The factory default setting for the port number is
[50001]. Unless you experience difficulty with this
setting, do not change the port number.
• To use the tandem function when user
authentication is enabled, the same login name and
password must be used on both the master
machine and slave machine. If the same login name
and password are not used, the page count may not
be added to the appropriate user count or only the
master machine may print.
When the document filing function is frequently used
and output of files seems somewhat slow, optimizing
the hard drive may improve performance.