Sharp MX-M264N - Manual (Page 668)

7-36
SYSTEM SETTINGS
Contents
Printer Settings
* When the hard disk drive is installed.
Image Send Settings
Item Factory default setting Page
P Printer Settings
7-74
N Default Settings 7-74
X Prohibit Notice Page Printing Enabled 7-74
X Prohibit Test Page Printing Disabled 7-74
X A4/Letter Size Auto Change Varies depending on country and region 7-74
X Print Density Level 3 7-74
X Bypass Tray Settings 7-74
‹ Enable Detected Paper Size in Bypass Tray Disabled 7-74
‹ Enable Selected Paper Type in Bypass Tray Enabled 7-74
‹ Exclude Bypass-Tray from Auto Paper Select Disabled 7-74
X Job Spool Queuing * Enabled 7-74
X Disabling of USB Memory Direct Print * Disabled 7-74
X Disabling of Network Folder Direct Print * Disabled 7-74
N Interface Settings 7-75
X Hexadecimal Dump Mode * Disabled 7-75
X I/O Timeout 60 sec. 7-75
X Enable USB Port Enabled 7-75
X USB Port Emulation Switching * Auto 7-75
X Enable Network Port Enabled 7-75
X Network Port Emulation Switching * Auto 7-75
X Port Switching Method Switch at End of Job 7-75
Item Factory default setting Page
P Image Send Settings
7-76
N Operation Settings 7-76
X Other Settings 7-76
‹ Default Display Settings Scan (fax when fax is installed)
7-76
• Hold settings for a while after scanning has been
completed
Disabled
‹ Address Book Default Selection Tab Switch: ABC, Address Type: All 7-76