Sharp MX-M264N - Manual (Page 701)

7-69
SYSTEM SETTINGS
Contents
Disabling of Devices
Use these settings when a peripheral device on the machine has failed or when you wish to temporarily disable a device.
Disabling of Document Feeder
(When the automatic document feeder is installed.)
Use this setting to prohibit the use of the automatic
document feeder, such as when the feeder malfunctions.
(When the setting is enabled, scanning is still possible
using the document glass.)
Disabling of Duplex
This is used to disable two-sided printing, such as when
the duplex module malfunctions.
Disabling of Optional Paper Drawer
(When an optional paper drawer is installed.)
This setting is used to disable the optional paper drawer,
such as when it malfunctions.
Disabling of Tray Settings
This setting is used to prohibit tray settings (except for
the bypass tray).
Disabling of Finisher
(When a finisher is installed.)
This setting is used to disable the finisher, such as when
the unit malfunctions.
Disabling of Offset
This setting is used to disable the offset function.
Disabling of Stapler
(When a finisher is installed.)
This setting is used to prohibit stapling, such as when
the stapler unit of the finisher malfunctions.
Fusing Control Settings
These are used to control the toner fusing temperature according to the weight of the paper.
These settings apply to plain paper, punched paper, pre-printed paper, letterhead paper, coloured paper, and user type paper.
You can select "60g/m
2 to 89g/m 2 " or "90g/m 2 to 105g/m 2 " ("16 to 23 lbs." or "23+ to 28 lbs.").
Plasmacluster Settings
(When the plasmacluster ion generator is installed.)
You can set how the plasmacluster ion generator behaves when the machine's power is ON and when it is OFF, and also
set the status indicators on the plasmacluster ion generator.
Plasmacluster Operation at
Powering On of Machine
The plasmacluster ion generator can be set to power on
when the machine is powered on. In addition, you can set the
airflow when the plasmacluster ion generator is powered on.
Plasmacluster Operation at
Powering Off of Machine
The plasmacluster ion generator can be set to power off
when the machine is powered off. In addition, you can set
the timer for powering off the plasmacluster ion generator.
Status Indicator Setting
These settings configure the status indicators on the
plasmacluster ion generator. Pattern1 indicates the
status of the job on the machine, pattern2 indicates the
status of the machine, and the pattern3 indicates the
status of fax reception.
• Be sure to use only paper that is in the same weight range as the weight range set here. Do not mix plain or other paper
that is outside the range with the paper in the tray.
• When settings are changed, the changes will take effect after the machine is restarted. To restart the machine see
" TURNING THE POWER ON AND OFF " (page 1-14) in "1. BEFORE USING THE MACHINE ".