Sharp MX-M264N - Manual (Page 196)

2-98
COPIER
Contents
ADDING A WATERMARK TO A COPY (Watermark)
This function requires the hard disk drive.
When making a copy, specific text can be added to the copy as a watermark. The density, angle, and pages (first page
only or all pages) can be selected for a watermark. The watermark is printed at the centre of the paper.
Printing "CONFIDENTIAL" on the paper
The following 12 selections are available for the stamp text.
Three levels can be selected for the density of the watermark.
The angle of a watermark can be selected in the range +90 degrees to -90 degrees in increments of 45 degrees.
CONFIDENTIAL PRIORITY PRELIMINARY FINAL
FOR YOUR INFO. DO NOT COPY IMPORTANT COPY
URGENT DRAFT TOP SECRET PLEASE REPLY
1
Touch the [Watermark] key in the stamp selection screen.
See steps 1 to 4 of " GENERAL PROCEDURE FOR USING STAMP " (page 2-81).
2
Touch the key of the watermark that you
wish to use.
3
Touch the [Exposure] key and set the
colour and density.
If you wish to darken the exposure, touch the key. If you
wish to lighten the exposure, touch the key.
When you have finished selecting the settings, touch the [OK]
key.
CONFIDENT
IAL
Cancel OK
PRIORITY CONFIDENTIAL
DO NOT COPY FOR YOUR INFO.
DRAFT URGENT
FINAL PRELIMINARY
COPY IMPORTANT
PLEASE REPLY TOP SECRET
Exposure
All Pages
First Page
Angle
Stamp
Watermark
2 1 3
45
(+90 -90)
Cancel OK
PRIORITY CONFIDENTIAL
DO NOT COPY FOR YOUR INFO.
DRAFT URGENT
FINAL PRELIMINARY
COPY IMPORTANT
PLEASE REPLY TOP SECRET
Exposure
2 1 3
All Pages
First Page
Stamp
Watermark
Angle
45
(+90 -90)