Sharp MX-M264N - Manual (Page 719)

7-87
SYSTEM SETTINGS
Contents
Scan Complete Sound Setting
This setting adjusts the volume of the beep that sounds
when scanning ends. The beep can also be turned off.
Default Output Tray
(When the exit tray unit is installed.)
This setting is used to select the default output tray for
printing a file stored by Scan to HDD.
The items that appear will vary depending the machine
configuration.
Disable Stamp for Reprinting
When a stored file is retrieved and printed, this setting
prohibits the selection of a "Stamp" setting in the special
modes. If a stamp setting is already selected, it will not
be possible to change the stamp setting.
This function can be used to prevent inconsistencies in
the printed information, such as that of the original date
in the file and the date the file is retrieved and printed.
Batch Print Settings
When printing files by batch printing, this setting is used
to prohibit the selection of the [All Users] key and the
[User Unknown] key in the user selection screen.
Erase Width Adjustment
This is used to set the default erase width for erase
function. Specify a value from 0
mm (0") to 20 mm (1") in
increments of 1 mm (1/8") for both edge erase and
centre erase.
Card Shot Settings
This is used to set the default original size for the card
shot function.
Both the X (horizontal) and Y (vertical) dimensions of the
original can be set from 25
mm (1") to 210 mm (8-1/2") in
increments of 1 mm (1/8").
Fit to Store Size
Enable this setting to have the [Fit to Store Size] key
always appear in the card shot screen.