Toshiba Magnia Z310 - Manual (Page 91)

4.3.2.4 RADIUS Selection Operation
The diagram below shows a sample operation when the access point selects a RADIUS server.
In this example, the access point (AP-A) in Domain A has been set according to the sample
settings above.
Domain A
CA-A
Domain B
RADIUS-A AP-A(MAGNIA)
STA-A
Router Router
AP-B(MAGNIA) CA-B RADIUS-B
STA-B
(Connected to
AP-A)
‡ @
‡ B
‡ C
‡ D
‡ A
EAP/Identity
Domain A\ –
Domain B \ –
RADIUS Server
RADIUS-A
RADIUS-B
Rule
Rule-A
Rule-B
(1) The station (STA-B) connects to the access point (AP-A).
(2) While comparing the "EAP/Identity" sent from the station (STA-B) with
the registered rule, the access point (AP-A) selects the compatible
RADIUS server (RADIUS-B).
(3) Authentication is done with the RADIUS server (RADIUS-B).
(4) The RADIUS server (RADIUS-B) notifies the access point (AP-A) that
the authentication was successful.
(5) The access point (AP-A) notifies the station (STA-B) that the
authentication was successful.
The access point (AP-A) allows the station (STA-B) to proceed with
communications.