Toshiba Magnia Z310 - Manual (Page 109)

4.4.3.2 Access point
The following is the setting procedure for the access point.
Step 1 Setting the 802.1X function at the access point.
Make settings for the 802.1X function.
The following procedure is to enable the 802.1X function. The other settings of the [Basic setting]
and [Access restriction] tabs are omitted.
The setting procedure for MAGNIA-SRV A is explained below. After setting MAGNIA-SRV A, also
set MAGNIA-SRV B.
To set MAGNIA-SRV B, see Sample Configuration (1).
1 Start the access point setting utility.
2 Select the [WEP] tab.
3 Set the following items and click the [RADIUS Setting] button.
Select [Used] in the [802.1X] component box.
Place a check mark in the [Distribute key] check box.
Do not place a c check mark in the [Reauthenticate before key distribution] check box.
Set 600 in the [Key change interval] edit box.
Select [13 byte] for the [Key length] radio button.