Toshiba Magnia Z310 - Manual (Page 126)

119
Access Point Configuration Utility Problems
Problem Correction
When the Access Point Configuration Utility starts,
the message "Loading of the library required for
communication with access point failed" is
displayed.
· The utility may be incorrectly installed. Reinstall the
utility.
When the Access Point Configuration Utility starts
or wireless LAN adapter is changed, the message
"The access point is disabled. The changes are
applied when the access point is enabled next" is
displayed.
· Check whether the driver is normally operating on
the server (access point).
When the network is connected from remote
computer with the Access Point Configuration
Utility, the message "Communication with the
access point failed" is displayed.
· Check whether the specified computer name is
correct.
· By using the ping command, check whether the
network is disconnected.
· The SNMP Extension Agent needs to be operating
on the server (access point). Check whether the
SNMP Extension Agent is correctly installed.
· Check whether the driver is normally operating on
the server (access point).
When the network is connected from a remote PC
with the Access Point Configuration Utility, the
message "Acquisition of property values failed" is
displayed.
· Check whether the specified community name is
correct.
· The access point may be busy. Wait a while and re-
execute the utility.
The Access Point Configuration Utility displays the
message "Reading of settings failed."
· The access point may be busy. Wait a while and re-
execute the utility.
· By using the ping command, check whether the
network is disconnected.
When setting contents are applied in the Access
Point Configuration Utility, the message "Writing of
settings failed."
· The access point may be busy. Wait a while and re-
execute the utility.
· By using the ping command, check whether the
network is disconnected.
· When the network is used from the remote PC, it
must be connected with a community name with
writing authority. Check whether the specified
community name is correct, and the authority is
correctly set up.
· Please check if you try to change the access point
settings from a wireless-LAN station which has
association with the access point. The above usage
is out of specification.