Konica Minolta bizhub C200 - Manual (Page 75)

C200 2-26
Specifying machine functions (software switch settings) 2
2.5.8 Specifying settings concerning transmission if the memory becomes full (mode 025)
Specify whether or not to send the transmission if the memory of this machine became full while scanning
the original.
Factory settings
Specifying the settings
During the production of this unit, the settings in the shaded cells were selected.
2.5.9 Specifying the maximum number of copies allowed with remote copying (mode 028)
Specify the maximum number of copies allowed when a document specified for remote copying is received.
Factory settings
Specifying the settings
During the production of this unit, the settings in the shaded cells were selected.
Bits 7654 3210
Settings 0100 0000 (HEX: 40)
Bits Description Settings Details
7-6 Specify whether or not to send the transmission if the mem-
ory of this machine became full while scanning the original. 00 Delete
01 Inquire (deleted if there is no
response to the inquiry or if
the "Quick Scan TX" func-
tion was used)
10 Inquire (sent if there is no re-
sponse to the inquiry or if
the "Quick Scan TX" func-
tion was used)
11 *Do not specify these set-
tings.
5-0 − 000000 *Do not change the settings
for these bits.
Bits 7654 3210
Settings 0110 0011 (HEX: 63)
Bits Description Settings Details
7 − 0 *Do not change the setting
for this bit.
6-0 Specify the maximum number of copies when a remote copy
document is received. 0000001 1 set
0000010 2 sets
0000011 3 sets
0000100 4 sets
.
.
.
1100011 99 sets
Others *Do not specify any settings
other than those mentioned
above.