Konica Minolta bizhub C200 - Manual (Page 28)

C200 1-17
Specifying network settings 1
8
Touch [1].
– For multiple exception settings, settings can be specified for Exception Setting "2" and "3".
9
Use the keypad to type in the starting and ending IP addresses, and then touch [OK].
– The IP address cannot be specified to begin with "0.", "127.", or a number greater than "224".
– To enter a number with less than 3 digits, touch [ →] to move the cursor to the next number.
10
Touching [OK] displays the following screen. To apply the new settings, turn the machine off, then on
again.
!
Detail
In order to specify SMTP authentication settings, the software switch settings must be specified. For
details, refer to
"Specifying security settings for e-mail receptions (mode 383)" on page 2-15 .
2
Reminder
When turning the machine off, then on again, wait about 10 seconds to turn the machine on after turning
it off. The machine may not operate correctly if it is turned on immediately after being turned off.