Konica Minolta bizhub C200 - Manual (Page 18)

C200 1-7
Specifying network settings 1
2
Note
After changing the settings for these parameters, the machine must be turned off, then on again.
Specifying the settings
1
In the Network Settings screen, touch [Basic Settings].
2
Touch [DHCP].
3
Select the method for retrieving the IP address, and then touch [OK].
– If the DHCP server is to be used, touch [Auto Input], and then continue with step 10.
– If a fixed IP address is to be used, touch [IP Input], and then continue with step 4.
4
Touch [IP Address].
5
Use the keypad to type in the IP address, and then touch [OK].
– The IP address cannot be specified to begin with "0.", "127.", or a number greater than "224".
– To enter a number with less than 3 digits, touch [ →] to move the cursor to the next number.
6
Touch [Subnet Mask].