Avaya C460 - Manual (Page 93)

Chapter 2 Avaya C460 CLI Commands
Avaya C460 Reference Guide 81
Example:
set arp-aging-interval
User level: read-write, admin.
Use the set arp-aging interval command to set the ARP table aging interval
for gateways’ entries in the agent ARP table.
The MAC value for the default gateway of the agent in the ARP table, is deleted at
the end of every aging interval. The default value is 10 minutes.
The syntax for this command is:
set arp-aging-interval
Example:
set arp-tx-interval
User level: read-write, admin.
Sets the keep-alive frames sending interval. Setting the interval to 0 disables the
transmission of the keep-alive frames.
The syntax for this command is:
set arp-tx-interval
C460-1(super)# set allowed managers ip add 149.49.32.134
Ip was added to the table
value The number representing the interval, from 0-10 minutes.
C460-1# set arp-aging-interval 10
ARP table aging interval for gateways was set to 10
minutes.
inband|outband • Inband – inband interface
• Outband – outband interface
value The interval in seconds. (0-3600)