Avaya C460 - Manual (Page 85)

Chapter 2 Avaya C460 CLI Commands
Avaya C460 Reference Guide 73
The default is disabled.
The syntax for this command is:
[no] redistribute
Example:
reset
User level: read-only, read-write, admin.
Use the reset command to restart the system or an individual Supervisor module.
The syntax for this command is:
reset [chassis | spvs | 1 | 2]
L If the Supervisor modules are in Active/Standby configuration, resetting the
active supervisor will cause the standby supervisor to take over and become
active.
L The reset command does not work during configuration saving.
protocol Either Static or OSPF
Router-1 (configure router:rip) # redistribute ospf
Done!
chassis • Reset the entire chassis, including the Supervisor and I/O
Modules
• Reset the hardware
• Causes disruption to traffic of 10 to 20 seconds
spvs • Reset both the Supervisor modules
• Minimal disruption to the traffic
1 Reset Supervisor module in slot 1
2 Reset Supervisor module in slot 2
C460-1# reset 1
This command will reset the Active SPV
*** Reset *** - do you want to continue (Y/N)? y
Reseting Active SPV...