Avaya C460 - Manual (Page 49)

Chapter 2 Avaya C460 CLI Commands
Avaya C460 Reference Guide 37
ip access-default-action
User level: read-write, admin.
L If you are at the ”read-write” user level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode if necessary.
Use the ip access-default-action command to set the default action for a
specific policy list.
The syntax for this command is:
ip access-default-action
action>
Example:
ip access-group
User level: read-write, admin.
L If you are at the ”read-write” user level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode if necessary.
Use the ip access-group command to activate a specific policy list.
Use the no ip access-group command to deactivate the policy list.
The syntax for this command is:
[no] ip access-group []
Example:
integer (100 to 149)
default-action-deny|default-action-permit
C460-1(configure)# access-default-action 101 default-
action-deny
integer (100 to 149)
0 is the default list
default-action-deny|default-action-permit
C460-1(configure)# ip access-group 101