Avaya C460 - Manual (Page 124)

Chapter 2 Avaya C460 CLI Commands
112 Avaya C460 Reference Guide
ports.
The syntax for this command is:
set port negotiation / {enable|disable}
Example:
To disable autonegotiation on port 1, module 4:
set port point-to-point admin status
User level: read-write, admin.
Use the set port point-to-point admin status command to set the port
RSTP point-to-point admin status.
The syntax for this command is:
set port point-to-point admin status
status>
module Number of the module (3-6). If you do not specify a number,
the ports on all the modules are configured.
port Number of the port on the module. If you do not specify a
number, the negotiation is set for all the ports on the module.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
enable Enable port negotiation protocol
disable Disable port negotiation protocol
C460-1# set port negotiation 4/1 disable
Link negotiation protocol disabled on port 4/1.
module Number of the module (3-6). If you do not specify a number, the
ports on all the modules are configured.
port Number of the port on the module. If you do not specify a number,
the negotiation is set for all the ports on the module.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
admin
status force-true - treat this port as if it is connected point-to-point
force-false - treat this port as if it is connected to shared media
auto - try to automaticaly detect the connection type of the port