Avaya C460 - Manual (Page 132)

Chapter 2 Avaya C460 CLI Commands
120 Avaya C460 Reference Guide
The syntax for this command is:
set port trap / {enable|disable}
Example:
set port vlan
User level: read-write, admin.
Use the set port vlan command to set the port VLAN ID (PVID). If adding a
new VLAN, the VLAN number must be within the range.
L You need to define a vlan before setting a port VLAN ID.
The syntax for this command is:
set port vlan /
module Number of the module (3-6).
port Number of the port on the module.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
enable Enable uplink/downlink traps
disable Disable uplink/downlink traps
C460-1# set port trap 3/2 enable
Port 3/2 up/down trap enabled.
vlan_num Number identifying the VLAN.
module The module number
port Number of the port on the module.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.