Avaya C460 - Manual (Page 136)

Chapter 2 Avaya C460 CLI Commands
124 Avaya C460 Reference Guide
The syntax for this command is:
set ppp incoming timeout
Example:
qset radius authentication enable/disable
User level: read-write, admin.
Enables or disables RADIUS authentication for the C460 switch.
The syntax for this command is:
set radius authentication {enable | disable}
Example:
set radius authentication retry-number
User level: read-write, admin.
Sets the number of times an access request is sent when there is no response.
The syntax for this command is:
set radius authentication retry-number
Example:
time The timeout in minutes
C460-1# set ppp incoming timeout 15
PPP incoming session will automatically disconnect after 15
minutes of idle time
enable Enable RADIUS authentication
disable Disable RADIUS authentication (default)
C460-1(super)# set radius authentication enable
number Number of retries
C460-1(super)# set radius authentication retry-number 3