Avaya C460 - Manual (Page 54)

Chapter 2 Avaya C460 CLI Commands
42 Avaya C460 Reference Guide
Example:
ip access-list-dscp trust
User level: read-write, admin.
Use the ip access-list-dscp trust command to decide which original
frame fields influence the selection of packet priority.
The syntax for this command is:
ip access-list-dscp trust
{untrusted|trust-cos |trust-dscp}
Example:
ip access-list-name
User level: read-write, admin.
L If you are at the “read-write” user level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode.
Use the ip access-list-name command to set a name for a policy list.
The syntax for this command is:
ip access-list-name
C460-1(configure)# ip access-list-dscp precedence
C460-1(configure)#
policy-list-
number A valid id number for a policy list currently defined for the module
(100 to 149)
untrusted Forward the packet with priority 0
trust-cos Forward the packet with its original 802.1p priority (default)
trust-dscp Forward the packet with the maximum priority between 802.1p and
the priority obtained from the DSCP-CoS mapping table
C460-1(configure)# ip access-list-dscp trust 100 trust-dscp
Done!
integer (100 to 149)