Avaya C460 - Manual (Page 116)

Chapter 2 Avaya C460 CLI Commands
104 Avaya C460 Reference Guide
The syntax for this command is:
set port dot1x re-authentication
Example:
set port dot1x re-authperiod
User level: admin.
Use the set port dot1x re-authperiod command to set the the idle time
between re-authentication attempts before the session is terminated.
The syntax for this command is:
set port dot1x re-authperiod
Example:
set port dot1x server-timeout
User level: admin.
Use the set port dot1x server-timeout command to set the time to wait for
a reply from the Authentication Server before the session is terminated.
module/
port Module and port number
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
mode • enable
• disable
C460-1(super)# set port dot1x re-authentication 1/2 enable
port 1/2 re-authenticate was set to enable
module/
port Module and port number
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
seconds Idle time in seconds – 0 to 65535
C460-1(super)# set port dot1x re-authperiod 1/2 400