Avaya C460 - Manual (Page 108)

Chapter 2 Avaya C460 CLI Commands
96 Avaya C460 Reference Guide
Example:
L The entered value is the aging-time lower bound. The actual aging-time might
be up to three minutes longer.
set outband duplex
User level: read-write, admin.
Use the set outband duplex command to configure the duplex type of the
Ethernet Console port.
You can configure the Ethernet Console interface to either full duplex or half
duplex.
The duplex status of a port in auto-negotiation mode is determined by auto-
negotiation and an error message is generated if you attempt to set the transmission
type of auto-negotiation Fast Ethernet ports to half- or full-duplex mode.
The syntax for this command is:
set outband duplex {full | half}
Example:
set outband negotiation
User level: read-write, admin.
Use the set outbound negotiation command to enable or disable the link
negotiation protocol on the Ethernet console port.
This command applies to the specific supervisor module where you execute it.
•
When negotiation is enabled, the speed and duplex of the outband Ethernet
port is determined by auto-negotiation.
• If negotiation is disabled, you can set the speed and duplex of the outband
Ethernet port.
C460-1# set mac-aging-time 5
mac aging time is set to 5 minutes.
Full Sets full-duplex transmission.
Half Sets half-duplex transmission
C460-1# set outband duplex full
Ethernet Console interface set to full-duplex.