Avaya C460 - Manual (Page 58)

Chapter 2 Avaya C460 CLI Commands
46 Avaya C460 Reference Guide
ip bootp-dhcp server
User level: read-write, admin.
L You can only access this command in Interface mode.
Type interface [name] at the command prompt to enter Interface mode if
necessary.
Use the ip bootp-dhcp server command to add a bootp/dhcp server to
handle bootp/dhcp requests received by this interface.
Use the no ip bootp-dhcp server command to remove the server. A
maximum of two servers can be added to a single interface.
The syntax for this command is:
ip bootp-dhcp server
Example:
To add station 192.168.37.46 as a bootp/dhcp server to handle bootp/dhcp requests
arriving at the interface “marketing”:
ip broadcast-address
User level: read-write, admin.
L You can only access this command in interface mode.
Type interface [name] at the command prompt to enter interface mode.
Use the ip broadcast command to update the interface broadcast address. The
Broadcast address must be filled in with 0s or 1s.
The syntax for this command is:
ip broadcast-address
Example:
ip-address The IP address of the server.
Router-1(configure-if:marketing) # ip bootp-dhcp server
192.168.37.46
Done!
bc addr The broadcast IP address
Router-1(config-if:marketing)#ip broadcast address
192.168.255.255