Avaya C460 - Manual (Page 59)

Chapter 2 Avaya C460 CLI Commands
Avaya C460 Reference Guide 47
ip default-gateway
User level: read-write, admin.
L If you are at the “read-write” user level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode.
Use the ip default-gateway command to define a default gateway (router).
Use the no ip default gateway command to remove the default gateway.
The syntax for this command is:
[no] ip default-gateway [][]
Example:
To define the router at address 192.168.37.1 as the default gateway:
ip directed-broadcast
User level: read-write, admin.
L You can only access this command in interface mode.
Type interface [name] at the command prompt to enter interface mode.
Use the ip directed-broadcast command to enable net-directed broadcast
forwarding.
Use the no ip directed-broadcast command to disables net-directed
broadcasts on an interface.
The syntax for this command is:
[no] ip directed-broadcast
Example:
ip-address The IP address of the router.
cost The path cost. The default is 1
preference Preference, either High or Low. Default is Low.
C460-1(configure)# ip default-gateway 192.168.37.1
Router-1(config-if:marketing)# ip directed broadcast