Avaya C460 - Manual (Page 56)

Chapter 2 Avaya C460 CLI Commands
44 Avaya C460 Reference Guide
Example:
To assign the IP address 192.168.22.33 with mask 255.255.255.0 to the interface
“marketing”:
ip admin-state
User level: read-write, admin.
L You can only access this command in interface mode.
Type interface [name] at the command prompt to enter interface mode.
Use the admin-state command to set the administrative state of an IP interface.
The default state is up.
The syntax for this command is:
ip admin-state
Example:
ip bootp-dhcp network
User level: read-write, admin.
L You can only access this command in Interface mode.
Type interface [name] at the command prompt to enter Interface mode if
necessary.
Use the ip bootp-dhcp network command to select the network from which
the bootp/dhcp server shall allocate an address. You only need to run this
command is required only when there are multiple interfaces over the VLAN.
Use the no ip bootp-dhcp network command to restore the default value.
mask Mask for the associated IP subnet
admin-state The administration status – either Up or Down
Router-1(config-if:marketing)# ip address 192.168.22.33
255.255.255.0
Done!
up/down Administrative state of the interface:
• up (active)
• down (inactive).
Router-1(config-if:marketing)# ip admin-state up