Aastra Telecom AastraLink Pro 160 - Manual (Page 88)

Configuring Groups
3-44 41-001190-02 Rev. 01, Rel. 1.2
AastraLink Pro 160 Administrator Guide
Distinctive Ring
(Not applicable to Paging
Groups)
Specifies a distinctive ring for all of the member’s
phones in the Ring Group. Valid values are:
• None (default - Tone 1)
• Pattern 1 (Tone 2)
• Pattern 2 (Tone 3)
• Pattern 3 (Tone 4)
• Pattern 4 (Tone 5)
Note: Distinctive ring tones apply to SIP extensions
only. Any 420d or SIP phones in a Ring Group
receive standard ring tone.
For more information about ring tone patterns, see
the section,
“Distinctive Ringing (Ring Groups only)”
on page 3-45 .
Rings Before Transfer
(Not applicable to Paging
Groups)
Specifies the number of rings on the Ring Group’s
phones before transferring the incoming call.
Valid values are 1 through 6. Default is 1.
Note: Transfer of the call is based on the setting of
the “Transfer to” parameter.
Transfer to
(Not applicable to Paging
Groups)
Specifies where the incoming call is transferred to if
there is no answer or if there is a busy signal on the
Ring Group’s phones. Valid values are:
• None (default)
• Extension
• Voicemail
• Auto-Attendant
Note: If you choose extension, you must specify the
extension at the “Transfer Number” parameter.
Transfer Number
(Not applicable to Paging
Groups)
Specifies the phone number or extension to transfer
unanswered incoming calls to. Valid values are the
registered phones with their extensions in your
AastraLink Pro 160 network.
Group Membership Specifies the members of the Ring Group or Paging
Group with their extensions. Only the members
selected become part of the Ring Group or Paging
Group you define. Default is NO MEMBERS.
Parameter Description