Aastra Telecom AastraLink Pro 160 - Manual (Page 333)

Reinstalling Aastra IP Phones at the Central Site
41-001190-02 Rev. 01, Rel. 1.2 A-13
Remote Office Configuration of the IP Phone (Phone-Side)
Reinstalling Aastra IP Phones at the Central Site
Use the procedure described in this section to reinstall an IP phone at the central
site that had been previously installed at a remote office.
The procedure described below resets the IP phone from “remote mode” to back
to “local mode.” If you do not reset the IP phone, it will attempt to boot in remote
mode when you install it.
Step Action
1 Connect the Aastra IP phone to your Ethernet Hub/Router.
Note: See your AastraLink Pro 160 Quick Start User’s Guide for instructions on setting up and
installing your Aastra IP phone.
2 Select when the IP phone UI prompts you to specify the IP address of the AastraLink
at your central site.
3 Press the key or button on your IP phone.
4 Use the arrow keys to view the options, then select
5 Press
6 Enter the administrator password, then press
7 Select when prompted to “Reset Phone Back to Factory Defaults.”
Enter server name/IP
Cancel
Done
65.215.35.80
Backspace
Dot .
abc
Select Cancel