Aastra Telecom AastraLink Pro 160 - Manual (Page 175)

Configuring Dial Plan Settings
41-001190-02 Rev. 01, Rel. 1.2 4-65
Configuring AastraLink Pro 160 System and Network Parameters
SLA Configuration Changes
If the AastraLink SLA configuration changes for any FXO, all phones are
rebooted for the line key change to be applied. If membership is changed for a
single phone, that phone only reboots.
When a User dials on an IP Phone, the phone assumes that the line on which the
user is dialing is a Pool line. If SLA is enabled on the phone, the phone changes its
behavior when the User dials out on a line. If SLA is enabled and specific features
on the phone are used (for example, redial, speeddial, transfer), the User must
specifically direct the feature to use the SLA line for the feature to work in that
mode.
The features affected by SLA include:
• Redial list
• Speed-dial softkey
• 3-way conference
• Call transfer
Note: If you enable the SLA feature on the AastraLink:
• Phone Xfer is not supported for SLA lines.
• Redial and Speed-dial default to using the Pool line.
• When the Speaker key is pressed, or receiver goes off-hook, Pool line is
automatically selected.
Redial
To perform a Redial using a Pool line.... press <Redial> then press <Redial> again.
To perform a Redial using an SLA line L1.... press <Redial> then press <L1> key.
Speeddial
To perform a Speeddial using the Pool
line.... press the Speeddial key.