Horner APG QX351 OCS HEQX351C103 - Manual (Page 43)

MAN0892-03-EN CH.10
February 25, 2010 Page 43 of 109 #1039
CHAPTER 10: SYSTEM SETTINGS AND ADJUSTMENTS
10.1
System Menu - Overview
The QX351 controller has a built-in System Menu, which lets the user view system settings and make
adjustments. To start the System Menu, press the SYSTEM key (or set %SR3 to 1), which will display
the Main Menu with options as shown in Figure 10.1. Then use the
and keys to select a Main
Menu item and press to display the item’s Sub-Menu.
Figure 10.1: System Menu
Network Ok? Yes
Network ID: 253
Network Baud: 125 KB
(Use
↓↑
to adjust)
Sub-Menus
Model: QX351
Mode: Idle
Scan Rate (mS): 0.0
Lcl Net Use (%): 0.0
All Net Use (%): 0.0
Ladder Size: 2
Config Size: 8
Graphics Size: 8
String Size: 8
Bitmap Size: 8
Text Tbl Size: 8
Font Tbl Size: 8
Protocol Size: 8
SMS File Size: 8
Firmware Rev: 11.76
BIOS Rev: 0.12
FPGA Rev: 2.8
Self-Test: Ok
Logic Error: Ok
User Program: Ok
User Graphics: Ok
W-Dog Trips: 0
Net Errors: 0
Network State: Ok
Network ID: Ok
Dup Net ID: Ok
Clock Error: Ok
I/O System: Ok
Battery:
Ok
Base Selected: CPU
Base Online? Yes
Slot 1:+I/O: FOX100
Slot 2:+I/O: ETN300
Slot 3:+I/O: Empty
Slot 4: I/O: Empty
Set Network ID
Set Network Baud
View Status
View Diags
View I/O Slots
View Protocols
Set Fkeys Mode
Set Serial ports
Set Time/Date
Set Beeper
Set Screen
Removable Media
Fail-Safe System
Clone Unit
(Press ESC to
Exit)
Main Menu
Port 1:
(None Loaded)
Port 2:
(None Loaded)
Sub-Menus
Fkeys: Momentary
Sys-Fn enable: Yes
(Use
↓↑
to adjust)
MJ1 RS485 Bias: No
MJ2 RS485 Bias: No
(Use
↓↑
to adjust)
Time: 10:21:36
Date: 22-Jun-2006
Day: Thursday
(Use
↓↑
to adjust)
( each field )
Saver enable: No
Timeout (min): 15
Popup Status: Off
Update Time (mS): 5
Update time sets
the maximum time
used by graphics
in the logic scan.
Media Directory
Media Card Not Present
Note: The QX display shows up
to 15 lines of text at a time. For
System Menu screens that
contain more than 15 lines of
text, use the
↓
and
↑
keys to
scroll the display.
Beeper enable: Yes
(Use
↓↑
to adjust)
Backup/Restore Data
Enable AutoRun
Enable AutoLoad
(ESC to exit)
Clone Unit
Directory Empty