Horner APG QX351 OCS HEQX351C103 - Manual (Page 34)

CH. 7 MAN0892-03-EN
February 25, 2010 Page 34 of 109 # 1039
If the register is Read / Write, the application should write an IP Address to the assigned register, and
this value will then be the unit’s IP Address. (In this case, the Default IP Address is used only if
communication is lost during an I/O configuration download; otherwise the Default IP Address is
ignored.)
Ethernet Module Register Usage - Enhanced Configuration
To perform Enhanced Configuration, first check the Enhanced Configuration checkbox. In this case,
IP Address, Net Mask, Gateway, Status and Version can all be optionally assigned to OCS registers.
By default, the register edit boxes are empty indicating that no registers are assigned.
As with the IP Address register (described in the Standard Configuration section above), Net Mask
and Gateway register Directions can be set to Read Only or Read / Write.
Ethernet Module Register Usage – General
For the Status and Version registers (if configured), the Direction settings are always Read Only.
The Use CAN ID for last Octet checkbox does not affect Net Mask, Gateway, Status or Version
configuration.
Ethernet Module Protocol Configuration
The Protocol Support area contains a list of all the protocols supported by the platform being
configured. To activate a protocol, check its checkbox.
For protocols that require additional configuration, click on a listed protocol to select it and then click
the Configure Selected Protocol button. This will open a new dialog with configuration options for
the selected protocol.
For detailed information on individual protocol configuration refer latest version of ETN 300 Manual
SUP0740.