Triton BathyPro - Manual (Page 3)

Safety Precautions
Please adhere to the hardware and software precautions mentioned
below. In addition, observe all safety precautions mentioned in this
manual.
When working with the overall system
1. Before handling components inside your computer system, exit all applications
and shut down the operating system in accordance with procedures applicable
to them.
2. Turn off the power to the computer and disconnect all cables that may be
feeding electrical power to the system you will be working on.
3. Wear a grounded, anti-static wrist-strap. This is especially important if you are
removing, replacing, or installing a printed circuit board of any kind.
Failure to adhere to these and other safety precautions mentioned in the manual could
result in harm to property or personnel!
When working with magneto-optical cartridge disks
• Please refer to the Appendix entitled “Mass Storage Options” for important details
covering the handling of M-O disks!
• Never boot your system with a writable M-O cartridge inserted into the drive!
• Use magneto-optical media that has 512 bytes per sector, not 1024 bytes per
sector, and use the AFDisk software utility to format magneto-optical media. Never
use Windows 95 to format M-O media!
Triton Elics Internatonal
125 Westridge Drive
Watsonville, CA 95076
USA
[email protected]
(831) 722-7373
© 1991-2004 Triton Elics International, Inc. All rights reserved. Printed in the U.S.A.