Boonton 4540 Peak Power Meter User Manual - Manual (Page 261)

Boonton 4540 Series RF Power Meter
Appendix A 8-7
NO. MESSAGE DESCRIPTION
-342
"Temp comp pwr non-mono"
-343 "Temp comp pwr out range"
-344 "Temp comp temp non-mono"
-345 "Temp comp temp out range"
-346 "Temp comp table length"
-347
"Err expand TC"
-348 "Temp comp # pwr entries"
-349 "Temp comp # temp entries"
-350 "Error queue overflow"
-360 ―Communication Error‖
-361 ―RTC Date Format‖
-362
―Snsr2 Page Blank‖
-363
―Snsr1 Page Blank‖
-
364
―Sensor access fault‖
-370
―Function not available‖
The procedure being attempted is not licensed for use.
-371 "Err CH2 Sensor Data" Checksum failure of the Channel 2 sensor EEPROM.
-372
"Err CH1 Sensor Data" Checksum failure of the Channel 1 sensor EEPROM .
-373 ―Measurement Error‖
-374 "DSP no results
-375
"Cmd not accepted"
-376 "I2C Timeout" Software has timed-out while communicating over the I2C bus.
-377
"No I2C Ack" Missing Acknowledge signal while assessing the I2C bus.
-397 "Err CW signal."
-399 "AutoSetup did not complete."