Display:pulse:tspan, Display:screensaver:brightness, Display:screensaver:state – Boonton 4540 Peak Power Meter User Manual User Manual
Page 154: Display:screensaver:time, Display:pulse:tspan -20, Display:screensaver:brightness -20, Display:screensaver:state -20, Display:screensaver:time -20, Boonton 4540 series rf power meter, Remote operation
Boonton 4540 Series RF Power Meter
Remote Operation
5-20
DISPlay:PULSe:TSPAN
(Note: This command is supplied for compatibility with the Model 4530 Power Meter)
Description:
Set or return the horizontal time span of the display in pulse mode. Time span = 10*
Time/Division. Optional units: minutes.
Syntax:
DISPlay:PULSe:TSPAN
Argument:
10e-8 to 100 sec in a 1-2-5 sequence,
300 s,
10, 20, 50, 100, 300, 600 min
Valid Modes:
Pulse mode
Note:
There are separate time bases for the modulated mode and the pulse mode. The
arguments selected are saved and restored independently by mode.
DISPlay:SCREensaver:BRIGhtness
Description:
Set or return the display backlight brightness in percent when dimmed..
Syntax:
DISPlay:SCREensaver:BRIGhtness
Argument:
Valid Modes:
All
DISPlay:SCREensaver:STATe
Description:
Set or return the state of the screensaver function. When ON, the screensaver dims the LCD
backlight to a specified intensity after a specified period of keyboard inactivity. GPIB activity
does not disturb display backlighting unless DISPlay:SCREensaver commands are sent.
Syntax:
DISPlay:SCREensaver:STATe
Argument:
Valid Modes:
All
DISPlay:SCREensaver:TIMe
Description:
Set or return the time in minutes of no activity that dims the display backlight.
Syntax:
DISPlay:SCREensaver:TIMe
Argument:
Valid Modes:
All