Boonton 4540 Peak Power Meter User Manual - Manual (Page 223)

Boonton 4540 Series RF Power Meter
Remote Operation 5-89
Table 5-1. SCPI COMMAND SUMMARY (continued)
SENSe[1|2]:CORRection:CALFactor
Set correction factor in dB. = -3.00 to 3.00
SENSe[1|2]:CORRection:DCYCle
Set/return duty cycle correction factor in percent.
= 0.01 to 100.0%
SENSe[1|2]:CORRection:FREQuency
Set channel frequency. = 0.001e9 to
110.00e9 Hz
SENSe[1|2]:CORRection:OFFSet
Set/return sensor offset value in dB. = -300 to
300
SENSe[1|2]:CORRection:TEMPcomp
Set/return temperature compensation. = { 0, 1, OFF,
ON }
SENSe[1|2]:FILTer:STATe
Set/return filter state. = OFF, AUTO, ON
SENSe[1|2]:FILTer:TIMe Set or return the current length of the integration filter on the
selected channel. = 0.002 to 16.000 seconds
SENSe[1|2]:IMPedance
Set/return impedance reference for voltage to power in ohms.
= 10.00 to 2500.00
SENSe[1|2]:PULSe:DISTal
Set/return distal parameter of the risetime. =
50.00 to 100.00
SENSe[1|2]:PULSe:ENDGT
Set/return pulse gate end position in percent of pulse time duration.
= 60.00 to 100.00
SENSe[1|2]:PULSe:MESIal
Set/return mesial parameter of the risetime. =
10.00 to 90.00
SENSe[1|2]:PULSe:PROXimal
Set/return proximal parameter of the risetime. =
0.00 to 50.00 percent
SENSe[1|2]:PULSe:STARTGT
Set/return pulse gate start position in percent of pulse timeduration.
= 0.00 to 40.00
SENSe[1|2]:PULSe:UNIT
Set/return pulse definitions units. = WATTS,
VOLTS
SENSe[1|2]:SENSOR:TYPE?
Returns the sensor type for the selected channel.
= NONE, CW, VOLT, PEAK
SENSe:MBUF:SIZe
Set/return size of measurement buffer for both channels.
= -1 (FIFO), 0 (disabled), 1 to 1048576 points
SENSe:MBUF:RATe
Set/return modulated mode meas buffer rate for both channels.
= 1.0 to 1000.0 points per second
SENSe:MBUF:POSition?
Returns the current meas buffer write index for both channels.